It has high speed and high torque to provide you with more power. It also features a stator rotor and S-bearing, resulting in high precision and strong pressure. It will be your powerful power source! This product adopts a powder metallurgy valve disc and low carbon alloy steel output shaft, with high wear. High precision, and long service life.
The oil seal adopts three layers of the sealing ring to bear pressure, which can effectively prevent oil leakage. The precision processed stator and rotor whose flatness error does not exceed 0.08 inches have high precision. The S-type bearing shaft has a strong radial force and high-pressure. Which can effectively extend the service life of the product.High speed (continuous: 879rpm; intermittent: 975rpm) and high torque (continuous: 81NM; intermittent: 108NM) bring you greater power. The one-piece construction allows you to start using the product directly without an additional installation. The rounded edges can effectively prevent you from being accidentally injured in the process of use.
Both knobs with a striped. Pattern effectively increase friction and make your operation easier. This product is generally applied to harvesting machines, augers, horizontal directional drilling rigs, coal mine type drilling rigs, trenching machines, lawn mower, food machinery, snow plow, concrete mixer, pump truck, sanitation machinery, machine tool, injection molding machinery, small crane, fishing machine, etc.
The normal operating oil temperature of this product is 68-140? , and the maximum system operating temperature is 194?(not more than 1 hour). Filter filtration accuracy is 10-30 microns, and it is better to add a magnetic block at the bottom of the oil tank to stop metal chips from entering the system.
The solid contamination level of working oil should not be higher than 19/16. Please select the appropriate hydraulic oil according to the actual operation and ambient temperature. The oil viscosity at 104 ° F is 42-74MM2/S. When used in series or parallel, the external drain must be used for pressure relief if the back pressure exceeds 10MPA (the rotating speed is lower than 200RPM).It is better to connect the external drain directly with the oil tank. The best working condition of the motor should be selected at the rated working condition of 1/3-2/3. In order to make the motor have a long service life, when adding load to the motor, it should first operate at 30% of the rated pressure for about 1 hour. In any case, please ensure that the motor is full of oil before adding load to the motor. Please allow the slight color difference caused by the shooting light and the 1-3 cm error due to manual measurement, and make sure you do not mind before ordering. Feedback is very important to us. It is impossible to address issues if we do not know about them! Faction is our ultimate goal. We work hard to earn your trust and future business.
A If you receive a defective item, you may return it or ask for a discount. Due to time zones, our reply to your questions may not be immediately. If it's non-workdays, please kindly be patient and wait till Monday.